WHOLE-BUILDING LCA ACCORDING WITH LEED V.4
Keywords:
LCA, Whole-building, LEED, Cut-off rulesAbstract
The LEED v4 Building Life-cycle Impact Reduction credit requires improved life cycle impacts compared to a baseline building. The baseline and proposed buildings must be functionally equivalent, i.e.: have comparable orientation and location, size, function and service life (>60 years) to fully account for maintenance and replacement but the proposed building must show improved energy performance. The life cycle assessment (LCA) scope is a cradle-tograve assessment of the building's structure and enclosure, following EN 15804:2013 system boundaries definition to encompass product, construction, use (except for energy and water), and end-of-life stages. Life cycle impacts must be calculated for six categories. A minimum 10% reduction relatively to the baseline must be demonstrated for global warming potential and other two impact categories, whilst no environmental impact category may increase by more than 5%. If all six impact categories are reduced by 10%, an extra point is awarded as Innovation credit. Typical cut-off criteria found in published whole-building LCAs is 5% of total mass and energy. Though LEED V4 tries to find the right balance between simplification whilst yielding meaningful LCA results, it applies a much larger cut-off rule. This paper explores the implications of such approach, through a Brazilian case study.
References
ASHRAE AMERICAN SOCIETY OF HEATING, REFRIGERATING AND AIR-CONDITIONINGENGINEERS. Energy Standard for Buildings Except Low-Rise Residential Buildings. SIedition. ASHRAE/ANSI/IES. Standard 90.1-2010. ANSI Approved; IES Co-sponsored.Atlanta, 2010.
DOBBELSTEEN, A.A.J.F., ARETS, M. AND NUNES, R. Sustainable design of supportingstructures. Optimal structural spans and component combinations for effectiveimprovement of environmental performance. Construction Innovation, v.7.n. 1. p.54-71, 2007.
EeB GUIDE PROJECT. Operational Guidance for Life Cycle Assessment Studies of theEnergy Efficient Buildings Initiative. October 2012.
EC JRC-IES EUROPEAN COMMISSION - JOINT RESEARCH CENTRE - INSTITUTE FORENVIRONMENT AND SUSTAINABILITY. International Reference Life Cycle Data System(ILCD) Handbook - General guide for Life Cycle Assessment - Detailed guidance.
March 2010. 1st. ed. Luxembourg. Publications Office of the European Union, 2010.
CEN EUROPEAN COMMITTEE FOR STANDARDISATION. EN 15804+A1: Sustainability ofconstruction works - Environmental product declarations - Core rules for the productcategory of construction products. Brussels, 2013.
CEN EUROPEAN COMMITTEE FOR STANDARDISATION. EN 15978: Sustainability ofconstruction works - Assessment of environmental performance of buildings -Calculation method. Brussels, 2011.
ISO INTERNATIONAL ORGANIZATION FOR STANDARDIZATION. ISO 14044:2006:Environmental management - Life cycle assessment - Requirements and guidelines.Geneve, 2006. 46 p.
LASVAUX, S.; ACHIM, F.; GARAT, P.; PEUPORTIER, B.; CHEVALIER, J. HABERT, G.
Correlations in Life Cycle Impact Assessment methods (LCIA) and indicators forconstruction materials: What matters? Ecological Indicators 67 (2016) 174 182.
USGBC UNITED STATES GREEN BUILDING COUNCIL. LEED Reference Guide for BuildingDesign and Construction. Washington D.C.: USGBC, 2013.
USGBC UNITED STATES GREEN BUILDING COUNCIL. LEED BD+C v4 Reference GuideAddenda Table. 1st ed. January, 27th 2017. Washington D.C.: USGBC, 2017.